Wheeler Chiostra sz 54 \\ a bit neo retro

Just finished fully rebuilding this one. Spent months sourcing the parts I wanted including some rare bars (8xtenos,) period saddles (NOS Selle San Marco Concour Light) cool stems and clean drive trains. Where needed, brakes, derailleurs, cranksets, etc were disassembled and thoroughly cleaned, and re assembled with fresh grease/lube/loctite. Brand new chains, brand new cables... The build has a 20 mile shakedown ride on it and is tuned and ready for many miles. Frame - 1992? Wheeler Chiostra Tange Prestige, i'd call it a 54cm Fork - Original Tange CroMo Headset - shimano 600 Wheelset - Shimano WH-R540 with some mismatched QRs Tires - Continental GP4000 25mm Front Derailleur - DA 7700 Rear Derailleur - Dura Ace 7700 w/ avid rollamajig Chain - chain - KMC x9 Cassette - ultegra CS6500 9 speed 12-28 Bottom Bracket - Ultegra Crankset - dura ace 7700 172.5 53/39 Stem - ITM Goccia 110mm Bars - modolo 8xtenos 410mm wrapped in Jaguar Green Deda Levers - dura ace 7700 2x9 Seatpost - 27.2 3k weave carbon with some setback, not sure of the make Saddle - NOS Selle San Marco Concor Light cromo rails Brakes - Ultegra 6500 *the crank brothers pedals aren’t included but I can throw in some other no name flats if you need **the RB-1 in the last photos of course isn't included but is also listed, check my other items Wheeler, out of Germany, maybe better known throughout the 90s for their mountain bikes or maybe for Mike Kluge (CX world champ/ Grundig Cup Champ!) who rode for them for a time. I think this model was called 8200 in other markets, it’s a super cool frame made from Tange Prestige, which was a top of the line tubeset at the time, in a dark metallic green(the last photo with the closeup is the best representation of the color) with rad decals, chromed fork/stays, pantograph, custom “wheeler” stamped rear dropouts and BB shell, internal rear brake cable routing, etc. In the catalogs of the time, this top model was specc'd with full Dura Ace. I’ve got it built with a slightly newer (than the frame) DA 9 speed group with a few Ultegra bits. It rides great and without even trying it sits sub 20lbs. It’s got a NOS SSM saddle that Lance favored and one of my favorite bend drop bars wrapped in Deda tape. Also an older/period Blackburn bottle cage and full Nissen x SimWorks cables. Frame Size 54 Seat Tube C-C 530mm Seat Tube C-T 540mm Top Tube C-C 540mm I am experienced with shipping and will pack carefully.  Depends on your location but likely UPS (bikeflights) will provide courier service. thanks for looking/reading.